Dell PowerEdge R7525 Installation and Service Manual

PDF

Removing the rear mounting front PERC module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the backplane cover.
  4. If installed, remove the air shroud.
  5. Remove the drive backplane.
  6. Disconnect all the cables, observe the cable routing.

Steps

  1. Using a Phillips #2 screwdriver, loosen the captive screws on the front PERC module.
    NOTE:The mounting bracket for the 24 x 2.5-inch backplane is on the right of the backplane. The removal of the PERC module is on the right side of the backplane.
  2. Slide the front PERC module to disengage from the connector on the drive backplane.
    Figure 1. Removing the rear mounting front PERC module

    This image shows Removing the rear mounting front PERC module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\