Dell PowerEdge R7525 Installation and Service Manual

PDF

Removing the serial COM port

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove expansion card riser.
  4. Disconnect the serial COM port cable from the connector on the rear I/O board.

Steps

  1. Open the latch on the expansion card riser and slide the serial COM port out of the expansion card riser.
    Figure 1. Removing the Serial COM port
    This image shows how to remove the serial COM port.
  2. Disconnect the serial COM port cable from the serial port.
    Figure 2. Removing the Serial COM port
    This image shows how to remove the Serial COM port.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\