Dell PowerEdge T550 Installation and Service Manual

PDF

Installing caster wheels

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Place the system on its side on a flat, stable surface.
  3. If installed, remove the system feet.
CAUTION:Install the caster wheels on a stand-alone tower system to provide stability to the system. An unstable system might tip over and cause injury or damage to the system.
NOTE:This T series server only uses Dell EMC caster wheels.

Steps

Align the caster wheel to the base of system and tighten the captive screw to secure the caster wheel into place.
Figure 1. Installing caster wheels
This image shows installing caster wheels.

Next steps

Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\