Dell PowerEdge T550 Installation and Service Manual

PDF

Installing the BOSS S2 module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure that is listed in Before working inside your system.
  3. Remove the air shroud.
  4. If installed, remove the front bezel.
  5. Disconnect the cables connected to the system board.

Steps

  1. If installed, remove the BOSS S2 module blank using a flat head screwdriver.
    Figure 1. Removing the BOSS S2 module blank
    This image shows removing the BOSS S2 module blank.
  2. Align the BOSS S2 module to the BOSS S2 slot on the chassis and push it into the slot.
  3. Using a Phillips 2 screwdriver, secure the BOSS S2 module to the system.
    Figure 2. Installing the BOSS S2 module
    This image shows installing the BOSS S2 module
    Figure 3. Installing the BOSS S2 module
    This image shows installing the BOSS S2 module

Next steps

  1. Connect the cables to the system board connectors.
    NOTE:Route the cables properly to prevent them from being pinched or crimped.
  2. If removed, install the front bezel.
  3. Install the air shroud.
  4. Follow the procedure that is listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\