Dell PowerEdge T550 Installation and Service Manual

PDF

Installing the GPU riser

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure that is listed in Before working inside your system.
  3. Remove the air shroud.

Steps

  1. Align the GPU riser to the guide pins and lower the GPU riser in the system.
  2. Tighten the captive screws, until the GPU riser is firmly seated.
    Figure 1. Installing the GPU riser
    This image shows how to install the GPU riser.

Next steps

  1. Connect the cables to the system board connectors.
  2. Install the air shroud.
  3. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\