Dell PowerEdge T550 Installation and Service Manual

PDF

Installing the system cover

Prerequisites

Follow the safety guidelines listed in Safety instructions.
NOTE:Ensure that all internal cables are connected and placed out of the way and no tools or extra parts are left inside the system.

Steps

  1. Align the tabs on the system cover with the guide slots on the system and slide the system cover.
  2. Close the system cover release latch.
    NOTE:Ensure that the system cover closes without obstruction or unnecessary force. Reseat any cables or components or realign the system cover if necessary.
  3. Using a 1/4-inch flat head or Phillips 2 screwdriver, rotate the lock clockwise to the lock position.
    Figure 1. Installing the system cover
    This image shows installing the system cover.

Next steps

  1. If removed, install the front bezel.
  2. Reconnect the peripherals and connect the system to the electrical outlet.
  3. Power on the system, including all attached peripherals.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\