Dell PowerEdge T550 Installation and Service Manual

PDF

Installing the tape backup unit blank

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure that is listed in Before working inside your system.
  3. If installed, remove the front bezel.

Steps

Align and slide the tape backup unit blank into the slot on the system until it clicks into place.
Figure 1. Installing the tape backup unit blank
This image shows how to install the tape backup unit blank.

Next steps

  1. If removed, install the front bezel.
  2. Follow the procedure that is listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\