Dell PowerEdge T550 Installation and Service Manual

PDF

Removing a drive bay

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure that is listed in Before working inside your system.
  3. Remove all the drives.
  4. Remove the backplane from drive bay.

Steps

  1. Using the Phillips 2 screwdriver, remove the screws securing the drive bay to the system.
  2. Slide the drive bay out of the system.
    NOTE:The procedure to remove the drive bays is similar for all configurations.
    Figure 1. Removing a drive bay
    This image shows removing a drive bay.
    Figure 2. Removing a drive bay
    This image shows removing a drive bay.
    Figure 3. Removing a NVMe drive bay
    This image shows removing a NVMe drive bay.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\