Dell PowerEdge T550 Installation and Service Manual

PDF

Removing the BOSS S2 card carrier

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure that is listed in Before working inside your system.
  3. If installed, remove the front bezel.

Steps

  1. Open the release latch and slide the BOSS S2 card carrier out of the BOSS S2 module.
    Figure 1. Removing the BOSS S2 card carrier
    This image shows removing the BOSS S2 card carrier
  2. If not installing the BOSS S2 card carrier, align and push the BOSS S2 card carrier blank into the BOSS S2 module to fill the empty BOSS S2 card carrier slot.
    Figure 2. Installing the BOSS S2 card carrier blank
    This image shows installing the BOSS S2 card carrier blank.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\