Dell PowerEdge T550 Installation and Service Manual

PDF

Removing the front PERC module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure that is listed in Before working inside your system.
  3. Disconnect all the cables connected to the front PERC module.

Steps

  1. Using a Phillips 2 screwdriver, loosen the captive screws on the front PERC module.
  2. Slide the front PERC module to disengage from the connector on the drive backplane.
    Figure 1. Removing the front PERC module for 3.5-inch drive backplane
    This image shows removing the front PERC module for 3.5-inch drive backplane.
    Figure 2. Removing the front PERC module for 2.5-inch drive backplane.
    This image shows removing the front PERC module for 2.5-inch drive backplane.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\