Dell PowerEdge T550 Installation and Service Manual

PDF

Removing the intrusion switch module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure that is listed in Before working inside your system.
  3. Remove the air shroud.
NOTE:Ensure that you note the routing of the cables as you remove them from the system board. Route the cable properly when you replace it to prevent the cable from being pinched or crimped.

Steps

  1. Disconnect the intrusion switch cable from the connector on the system board.
  2. Using a Phillips 2 screwdriver, remove the screw securing the intrusion switch to the system.
  3. Slide the intrusion switch module out of the slot on the system.
    Figure 1. Removing the intrusion switch module
    This image shows removing the intrusion switch module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\