Dell PowerEdge T550 Installation and Service Manual

PDF

Removing the M.2 SSD module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure that is listed in Before working inside your system.
  3. Remove the BOSS S2 module.

Steps

  1. Using the Phillips #1 screwdriver, remove the screws securing the M.2 SSD module to the BOSS card.
  2. Pull the M.2 SSD module to disconnect from the BOSS card connector.
    Figure 1. Removing the M.2 SSD
    This image shows removing the M.2 SSD.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\