Dell PowerEdge T550 Installation and Service Manual

PDF

Removing the MicroSD card

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure that is listed in Before working inside your system.
  3. Remove the IDSDM module.

Steps

  1. Locate the MicroSD card slot on the IDSDM module, and press the card to partially release it from the slot. For more information on the IDSDM module location, see System board jumpers and connectors section.
  2. Hold the MicroSD card, and remove them from the IDSDM module.
    NOTE:Temporarily label each MicroSD card with the corresponding slot number after removal.
    Figure 1. Removing the MicroSD card
    This image shows how to remove the MicroSD card.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\