Dell PowerEdge T550 Installation and Service Manual

PDF

Removing the power interposer board

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure that is listed in Before working inside your system.
  3. Remove the air shroud.
  4. Remove the PSU.

Steps

  1. Disconnect all the power cables from the PIB.
  2. Using the Phillips 2 screwdriver, remove the screws that secure the PIB to the system.
  3. Lift the PIB out of the system.
    Figure 1. Removing the PIB
    This image shows removing the power interposer board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\