Dell PowerEdge XE9785 Installation and Service Manual

PDF

Installing an EDSFF E3.S Gen5 NVMe drive into the drive carrier

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Remove the drive carrier.

Steps

  1. Insert the drive into the drive carrier with the drive connector facing towards the rear of the carrier.
  2. Align the screw holes on the drive with the screws holes on the drive carrier.
  3. Using a Torx 6 screwdriver, secure the drive to the drive carrier with the screws.
    NOTE:When installing a drive into the drive carrier, ensure that the screws are torqued to 4 lbf-in.
    Torx screw image
    Figure 1. Installing an EDSFF E3.S Gen5 NVMe drive into the drive carrier

    This image shows installing a EDSFF E3.S Gen5 NVMe drive into the drive carrier

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\