Dell PowerEdge XE9785 Installation and Service Manual
Installing the bus bar power cables
Prerequisites
- Follow the safety guidelines listed in the Safety instructions.
Steps
Align and insert the bus bar power cable connectors on the PIB and the
midplane.Figure 1. Installing the bus bar
power cables 
Next steps
- Install the HPM sled cover.
- Install the HPM sled.
- Follow the procedure listed in After working inside your system.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\