Dell PowerEdge XE9785 Installation and Service Manual

PDF

NIC port specifications

The PowerEdge XE9785 system supports up to two 10/100/1000 Mbps Network Interface Controller (NIC) ports on the front I/O card and an optional Open Compute Project (OCP) card.
Table 1. NIC port specification for the systemThis table describes the NIC port specification for the system.
Feature Specifications
Ethernet ports on the Front I/O board 2 x 1 Gb
OCP NIC 3.0 card 200 GbE x 2, 100 GbE x 2, 25 GbE x 4, 25 GbE x 2, 10 GbE x 4, 10G x 2
DPU card 400 GbE x 2*, 200 GbE x 2
PCIe Add-in Card (AIC) NIC 400 GbE x 1, 200 GbE x 2, 100 GbE x 2
NOTE:Feature not available at initial product launch. Refer to the product configurator page on Dell.com to confirm feature availability.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\