Dell PowerEdge XE9785 Installation and Service Manual

PDF

Removing the M.2 NVMe SSD module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.

Steps

  1. Pull the retention latch lock on the BOSS-N1 DC-MHS card carrier to open.
  2. Slide the BOSS-N1 DC-MHS card carrier out.
    Figure 1. Removing the BOSS-N1 DC-MHS card carrier
    This image shows the removing the BOSS-N1 DC-MHS card carrier
  3. Using the Phillips 1 screwdriver, loosen the captive screws securing the top cover of the BOSS-N1 DC-MHS card carrier.
    NOTE:Follow the sequence to loosen the captive screws. First, loosen the screw at the connector end, and then the screw at the front handle end.
    Figure 2. Loosen the top cover captive screws
    This image shows loosen the top cover captive screws
  4. Tilt the top cover from the side and lift the top cover out of the BOSS-N1 DC-MHS card carrier.
    Figure 3. Removing the top cover
    This image shows removing the top cover
  5. Lift the M.2 NVMe SSD module to disconnect from the BOSS-N1 DC-MHS carrier connector.
    Figure 4. Removing the M.2 NVMe SSD module
    This image shows the removal of the M.2 NVMe SSD module

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\