Dell PowerEdge XE9785 Installation and Service Manual

PDF

Removing the OCP NIC

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Remove the HPM sled.
  3. Remove the storage module sled cover.

Steps

  1. Loosen the captive screw on OCP NIC.
  2. Pull the OCP NIC using the plastic holder.
    Figure 1. Removing the OCP NIC
    This image shows removing the OCP NIC.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\