Dell PowerEdge XE9785 Installation and Service Manual

PDF

Removing the PCIe expansion cards

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Remove the HPM sled.
  3. Remove the HPM sled cover.
  4. Remove the storage module sled cover.
  5. Slide out the storage module sled.
  6. Remove the PCIe air shroud.
  7. NOTE:Disconnect the OCP NIC cable, and DRAC RJ45 network cables.

Steps

  1. Pull the PCIe expansion card to disengage it from the PSRBB or PSBB (PCIe Switch Retimer Base Board/ PCIe Switch Base board).
  2. Lift the PCIe expansion card out of the system.
    Figure 1. Removing the PCIe expansion cards
    Removing the PCIe expansion card
  3. If the PCIe expansion card is not going to be installed or replaced, install the filler.
    Figure 2. Installing the filler
    Installing the filler.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\