Dell PowerEdge XE9785 Installation and Service Manual

PDF

Replacing the BOSS-N1 DC-MHS Module Cable

Steps

  1. To remove the BOSS cable:
    1. Using a Torx‑8 screwdriver, remove the two screws on the BOSS tray..
    2. Identify the BOSS signal connector on the PSRBB/PSBB, hold the blue tag and pull it outward to release the signal cable.
    Figure 1. Removing the BOSS-N1 DC-MHS Module Cable
    The image shows removing the BOSS-N1 cable.
  2. To replace the BOSS cable:
    1. Align the BOSS cable with the slots on the storage‑module tray, then tighten the two screws with a Torx‑8 screwdriver
    2. Connect the signal cable firmly to the PSRBB/RSBB (BOSS) connector.
    Figure 2. Removing the BOSS-N1 DC-MHS Module Cable
    The image shows replacing the BOSS-N1 cable.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\