Dell PowerEdge XE9785 Installation and Service Manual

PDF

Running the Embedded System Diagnostics from the Boot Manager

Steps

  1. Download the UEFI ePSA Diagnostics SWB from the Dell support site.
  2. Install the UEFI ePSA Diagnostics SWB from iDRAC Web Interface.
  3. Power cycle the system and Press F11 during boot.
  4. Select System Utilities → Launch Diagnostics.
    The ePSA Pre-boot System Assessment window is displayed, listing all devices detected in the system. The diagnostics start running the tests on all the detected devices.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\