Dell PowerEdge XR8720t Installation and Service Manual

PDF

Installing the OCXO with GNSS (optional) module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. For Network optimized configurationRemove the OCP card riser.
  4. For Flexible configurationRemove the expansion card risers.

Steps

  1. Align the two guide pins with the module and insert it in to the connector on the HPM.
  2. Press on the blue touch point to firmly seat the module.
  3. Tighten the captive screw (6.0 +/- 0.2 in-lbf) to secure the module.
    Figure 1. Installing the OCXO with GNSS (optional) module Installing the OCXO with GNSS (optional) module

Next steps

  1. For Network optimized configurationInstall the OCP card riser.
  2. For Flexible configurationInstall the expansion card risers.
  3. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\