Dell PowerEdge XR8720t Installation and Service Manual

PDF

Installing the sled cover

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Ensure that all internal cables are connected and routed properly, and no tools or extra parts are left inside the system.

Steps

  1. Align the tabs on the sled cover with the guide slots on the sled and place down the sled cover.
  2. Slide the cover towards the rear of the system until it locks in to place and tighten the captive screw to secure it.
    Figure 1. Installing the sled cover

    This image shows installing the sled cover.

Next steps

Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\