Dell PowerEdge XR8720t Installation and Service Manual

PDF

Removing the co-planar SFP module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the OCP card riser.
  4. Remove the floating SFP module.

Steps

  1. Disconnect the cable from HPM.
  2. Loosen and remove the screw and lift the co-planar SFP module from the sled.
    Figure 1. Removing the co-planar SFP module
    This image shows the removing the coplanar SFP module

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\