Dell PowerEdge XR8720t Installation and Service Manual

PDF

Removing the OCP expansion card riser

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system
  3. Remove the OCP card .

Steps

  1. Loosen and remove the two screws on the side of the sled.
  2. Loosen the two captive screws on the riser and lift it up to remove from the sled.
    Figure 1. Removing the OCP expansion card riser (R1a)
    This image shows removing the OCP expansion card riser (R1a).

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\