
XPS 15 Service Manual
Procedure
NOTE The touch-screen cable
is available only on laptop configurations with touch displays.
- Disconnect the power-adapter port cable and speaker cable from the system-board assembly.
- Open the latch and disconnect the keyboard-control board cable and touchpad cable from the system-board assembly.
- Peel the tape to access the fingerprint reader cable.
- Open the latch and disconnect the fingerprint reader cable (optional) from the system-board assembly.
- Peel off the tape that secures the touch-screen cable to the system-board assembly if applicable.
- Peel the tape and then disconnect the touch-screen cable from the system-board assembly if applicable.
Figure 1. Disconnecting the cables 
- touchpad cable
- keyboard control-board cable
- power-adapter port cable
- speaker cable
- fingerprint reader cable (optional)
- tape
- tape
- touch-screen cable (optional)
- tape
- Remove the four screws (M2x4) that secure the system-board assembly to the palm-rest assembly.
- Lift the system-board assembly off the palm-rest assembly.CAUTION Do not hold the system board on the area of heat transfer and circuitry.
Figure 2. Removing the system board 
- system-board assembly
- screws (4)
- palm-rest assembly
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\