Skip to main content

XPS 16 9640 Owner's Manual

Installing the base cover

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following images indicate the location of the base cover and provide a visual representation of the installation procedure.

Figure 1. Installing the base cover
Image: Installing the base cover - 1
Figure 2. Installing the base cover
Image: Installing the base cover - 2
NOTE: Ensure that the battery cable is connected to the battery. To connect the battery cable, follow step 4 in the battery installation procedure.

Steps

  1. Align and place the base cover into the slots on the palm-rest assembly.
  2. Replace the eight screws (M2x4, T5) that secure the base cover to the palm rest and keyboard assembly.

Next steps

  1. Follow the procedure in After working inside your computer.
    NOTE:After installing the base cover, install the microSD card in the microSD card slot, if applicable.
    NOTE:Ensure that your computer is in Service Mode. For more information, see Before working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\