Skip to main content

XPS 16 9640 Owner's Manual

Installing the battery cable

CAUTION:The information in this installation section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the battery cable and provides a visual representation of the installation procedure.
Figure 1. Installing the battery cable
Image: Installing the battery cable

Steps

  1. Connect the battery cable to the connector on the battery.
  2. Adhere the tape to secure the battery cable to the battery.
  3. Turn the battery over.

Next steps

  1. Install the battery.
  2. Install the base cover.
  3. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\