Skip to main content

XPS 16 9640 Owner's Manual

Installing the speakers

CAUTION:The information in this installation section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the speakers and provides a visual representation of the installation procedure.

Figure 1. Installing the speakers
Image: Installing the speakers

Steps

  1. Using the alignment posts, place the speaker (R) into the slots on the palm rest and keyboard assembly.
  2. Using the alignment posts, place the speaker (L) into the slots on the palm rest and keyboard assembly.
    NOTE:Ensure that the alignment posts are threaded through the rubber grommets on the speaker.

Next steps

  1. Install the system board.
    NOTE:The system board can be installed along with the solid state drive.
  2. Install the Type-C brackets.
  3. Install the heat sink.
  4. Install the fans.
  5. Install the battery.
  6. Install the base cover.
  7. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\