Skip to main content

XPS 16 9640 Owner's Manual

Installing the Type-C brackets

CAUTION:The information in this installation section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the Type-C bracket and provides a visual representation of the installation procedure.

Figure 1. Installing the Type-C brackets
Image: Installing the Type-C brackets

Steps

  1. Align and the screw holes on the right Type-C bracket with the screw holes on the system board.
  2. Replace the two screws (M2x4.5) that secure the right Type-C bracket to the system board.
  3. Align and the screw holes on the left Type-C bracket with the screw holes on the palm rest and keyboard assembly and system board.
  4. Replace the three screws (M2x4.5) that secure the left Type-C bracket to the palm rest and keyboard assembly and system board.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\