- Notes, cautions, and warnings
- Views of XPS 16 9640
- Set up your XPS 16 9640
- Specifications of XPS 16 9640
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports and slots
- Internal slots
- Wireless module
- Audio
- Storage
- Media-card reader
- Keyboard
- Camera
- Touchpad
- Power adapter
- Battery
- Display
- Fingerprint reader
- Sensors
- GPU—Integrated
- GPU—Discrete
- Multiple display support matrix
- Hardware security
- Operating and storage environment
- Dell support policy
- Dell low blue light display
- Working inside your computer
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locating the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Network power cycle
- Drain flea power (perform hard reset)
- Getting help and contacting Dell Technologies
- Revision history
XPS 16 9640 Owner's Manual
Installing the wireless-module shield
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
About this task
Steps
- Align the screw hole on the wireless-module shield with the screw hole on the system board.
- Replace the screw (M2x3) that secures the wireless-module shield to the system board.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\