Skip to main content
Contact Us

XPS 16 9640 Owner's Manual

PDF

Removing the heat sink—Integrated GPUs

CAUTION:The information in this removal section is intended for authorized service technicians only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.

About this task

CAUTION:The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you touch it.
NOTE:For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The oils in your skin can reduce the heat transfer capability of the thermal grease.
The following image(s) indicate the location of the heat sink on computers that are shipped with integrated GPUs and provides a visual representation of the removal procedure.
Figure 1. Removing the heat sink—Integrated GPUs
Image: Removing the heat sink—Integrated GPUs

Steps

  1. In reverse sequential order (4>3>2>1), loosen the four captive screws that secure the heat sink to the system board.
  2. Lift the heat sink off the system board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\