Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell EMC SmartFabric OS10 User Guide Release 10.5.1

PDF

destination

Sets the destination where monitored traffic is sent to. The monitoring session can be local, RPM, or ERPM.

Syntax
destination {interface interface-type | remote-vlan vlan-id}
Parameters
interface-type—Enter the interface type for a local monitoring session.
  • ethernet node/slot/port[:subport]—Enter the Ethernet interface information as the destination.
  • port-channel id-number—Enter a port-channel number as the destination, from 1 to 128.
  • vlan vlan-id—Enter a VLAN ID as the destination, from 1 to 4093.
remote-vlan vlan-id—Enter a remote VLAN ID as the destination for the RPM monitoring session, from 1 to 4093.
Default
Not configured
Command Mode
MONITOR-SESSION
Usage Information
The no version of this command resets the value to the default.

This command is introduced on the MX9116n and MX5108n with support for full-switch mode from the Dell EMC SmartFabric OS release 10.4.0(R3S).

Example 
OS10(conf-mon-local-10)# destination interface port-channel 10
OS10(conf-mon-rpm-source-3)# destination remote-vlan 20
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\