Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell EMC SmartFabric OS10 User Guide Release 10.5.1

PDF

enable

Enables a specific privilege level.

Syntax
enable privilege-level
Parameters
  • privilege-level—Enter the configured privilege level, from 0 to 15.
Defaults
15
Command Mode
Exec
Usage Information

Dell EMC Networking recommends configuring a password for privilege level 15 using the enable password command. If you do not configure a password for a level, you can switch to that level without entering a password, unless a password is configured for a highest intermediate level. If you configure a password for an intermediate level, enter that password when prompted. To access privilege level 15, you must configure the enable password command. If you do not configure a password for privilege level 15, you cannot enter level 15. For privilege levels 0 to 14, the enable password command is optional.

Privilege levels inherit all permitted commands from all lower levels. For example, if you log in to privilege level 10 using the enable 10 command, all commands that are assigned to privilege level 10 and lower are available for use.

Example
OS10# enable
OS10# enable 10
Supported Releases
10.4.3.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\