Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell EMC SmartFabric OS10 User Guide Release 10.5.1

PDF

ip pim rp-candidate

Configures the router as an IPv4 PIM RP candidate.

Syntax

ip pim [vrf vrf-name] rp-candidate {ethernet node/slot/port[:subport] | loopback loopback-interface-number | vlan vlan-number | port-channel port-channel-number} [priority priority-value] [acl acl-name]

Parameters
  • vrf vrf-name—Enter the keyword vrf, then the name of the VRF
  • loopback-interface-number—Enter a value from 0 to 16383
  • vlan-number—Enter a value from 1 to 4093
  • port-channel-number—Enter a value from 1 to 128
  • priority-value—Enter a value from 0 to 255
  • acl-name—Standard ACL name
Default
Priority is 192.
Command Mode
CONFIGURATION
Usage Information

Specify the interface to obtain the candidate RP address. The access-list acl-name adds a range of group addresses that this candidate RP can serve.

If you do not specify an access list, the C-RP advertises itself to the entire multicast range, 224.0.0.0./4.

If you specify an access list, the C-RP advertises only the group range that the access list permits.

The no form of the command removes the router from being a C-RP. You must specify the parameters with the no form of this command.

Example
OS10# configure terminal
OS10(config)# ip pim vrf red rp-candidate loopback 10 priority 11 acl rp-grp
Supported Releases
10.5.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\