Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell EMC SmartFabric OS10 User Guide Release 10.5.1

PDF

ipv6 prefix-list seq permit

Configures a filter to permit route filtering from a specified prefix-list.

Syntax
ipv6 prefix-list [name] seq num permit A::B/x [ge | le} prefix-len
Parameters
  • name — (Optional) Enter the name of the IPv6 prefix-list.
  • num — Enter the sequence number of the specified IPv6 prefix list.
  • A::B/x — Enter the IPv6 address and mask in /prefix format (/x).
  • ge — Enter to indicate the network address is greater than or equal to the range specified.
  • le — Enter to indicate the network address is less than or equal to the range specified.
  • prefix-len — Enter the prefix length.
Defaults
Not configured
Command Mode
CONFIGURATION
Usage Information
The no version of this command removes the specified prefix-list.
Example
OS10(config)# ipv6 prefix-list TEST seq 65535 permit AB10::1/128 ge 30
Supported Release
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\