Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell EMC SmartFabric OS10 User Guide Release 10.5.1

PDF

seq permit udp (IPv6)

Assigns a sequence number to allow UDP IPv6 packets while creating a filter.

Syntax
seq sequence-number permit udp [A::B | A::B/x | any | host ipv6-address [operator]] [A::B | A:B/x | any | host ipv6-address [operator]] [ack | fin | psh | rst | syn | urg] [capture | count | dscp value | fragment | log]
Parameters
  • sequence-number — Enter the sequence number to identify the route-map for editing and sequencing number, from 1 to 16777214.
  • A::B — Enter the IPv6 address in hexadecimal format separated by colons.
  • A::B/x — Enter the number of bits that must match the IPv6 address.
  • any — (Optional) Enter the keyword any to specify any source or destination IP address.
  • host ipv6-address — (Optional) Enter the IPv6 address to use a host address only.
  • operator — (Optional) Enter a logical operator to match the packets on the specified port number. The following options are available:
    • eq — Equal to
    • gt — Greater than
    • lt — Lesser than
    • neq — Not equal to
    • range — Range of ports, including the specified port numbers.
  • ack — (Optional) Set the bit as acknowledgment.
  • fin — (Optional) Set the bit as finish—no more data from sender.
  • psh — (Optional) Set the bit as push.
  • rst — (Optional) Set the bit as reset.
  • syn — (Optional) Set the bit as synchronize.
  • urg — (Optional) Set the bit set as urgent.
  • capture — (Optional) Capture packets the filter processes.
  • count — (Optional) Count packets the filter processes.
  • byte — (Optional) Count bytes the filter processes.
  • dscp value — (Optional) Permit a packet based on the DSCP values, from 0 to 63.
  • fragment — (Optional) Use ACLs to control packet fragments.
  • log — (Optional) Enables ACL logging. Information about packets that match an ACL rule are logged.
Default
Not configured
Command Mode
IPV6-ACL
Usage Information

OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter’s sequence number.

Example
OS10(config)# ipv6 access-list egress
OS10(conf-ipv6-acl)# seq 5 permit udp any any capture session 1 log
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\