SUU uses the DUP to update the various system components.
During a Linux update, the DUP creates the .spsetup file using the
Linux lockfile utility at /var/lock. This file is created when
one of the following situations occur:
A kernel panic
A system restart command during a DUP procedure, preventing
a TERM signal from interrupting or stopping a running process
If one of these conditions occur, a /var/lock/.spsetup file is created, causing SUU to report a successful update and prompt
the user to restart the system. When you run SUU again and run the
Comparison Report, the comparison procedure reports no change in device
status. If this situation occurs and if you are not running an update,
delete the /var/lock/.spsetup file.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\