Dell Latitude 5480 Owner's Manual

PDF

Installing display assembly

Steps

  1. Place the chassis on the edge of a plane surface.
  2. Align the display assembly to align with the screw holders on the computer.
  3. Tighten the M2*5 screws to secure the display assembly to the computer.
  4. Connect the display cable to the connector on the system board.
  5. Place the metal bracket to secure the display cable.
  6. Tighten the M2*5 screws to secure the display cable.
  7. Route the WLAN and WWAN cables through the routing channels.
  8. Install the:
    1. display hinge cover
    2. hard drive assembly(optional)
    3. WLAN card
    4. WWAN card(optional)
    5. battery
    6. base cover
  9. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\