Dell Latitude 5480 Owner's Manual

PDF

Installing heat sink

Steps

  1. NOTE This section is for UMA model only.
    Place the heat sink on the system board.
  2. Tighten the M2*3 screws to secure the heat sink to the computer.
  3. Install the:
    1. battery
    2. base cover
  4. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\