Dell Latitude 5480 Owner's Manual

PDF

Installing system board

Steps

  1. Align the system board with the screw holders on the computer.
  2. Tighten the M2*2 screws to secure the system board to the computer.
  3. Place the metal bracket to secure the DisplayPort over USB Type-C.
  4. Tighten the M2*2 screws to secure the metal bracket on the DisplayPort over USB Type-C.
  5. Connect the power connector port cable to the connector on the system board.
  6. Connect the display cables to the connectors on the system board.
  7. Place the metal bracket to secure the display cable.
  8. Tighten the M2*2 screw to secure the metal bracket.
  9. Connect the following cables:
    1. touchpad
    2. USH board
    3. LED board
  10. Install the:
    1. chassis frame
    2. system fan
    3. heat sink
    4. coin cell battery
    5. memory module
    6. SSD card
    7. WLAN card
    8. WWAN card(optional)
    9. hard drive assembly(optional)
    10. keyboard
    11. keyboard trim
    12. battery
    13. base cover
    14. SIM card
  11. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\