Dell Latitude 5480 Owner's Manual

PDF

Removing display assembly

Steps

  1. Follow the procedure in Before working inside your computer.
  2. Remove the:
    1. base cover
    2. battery
    3. WLAN card
    4. WWAN card (optional)
    5. hard drive assembly(optional)
    6. display hinge cover
  3. To disconnect the display cable:
    1. Release the WLAN and WWAN cables from the routing channels [1].
    2. Remove the M2*5 screw that secures the display cable bracket to the computer [2].
    3. Remove the display cable bracket that secures the display cable [3].
    4. Disconnect the display cable from the connector on the system board [4].
    5. Remove the screw to release the display cable from the computer [5].
    Figure displaying how to remove the display cable from the computer.
  4. To release the display assembly:
    1. Remove the M2*5 screws that secure the display assembly to the computer [1].
    2. Release the WLAN cable, WWAN cable and display cable through the routing channels [2] [3].
    Figure displaying how to release the display assembly from the computer.
  5. Turn over the computer.
  6. To remove the display assembly:
    1. Remove the screws that secure the display assembly to the computer [1].
    2. Open the display [2].
      Figure displaying how to release the display assembly from the computer.
    3. Lift the display assembly from the computer.
      Figure displaying how to remove the display assembly from the computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\