- Notes, cautions, and warnings
- Working on your computer
- Disassembly and reassembly
- Recommended tools
- Screw list
- Subscriber Identity Module (SIM) card
- Micro Secure Digital (SD) Card
- Display panel assembly
- Solid-state drive
- WLAN card
- WWAN card
- Battery
- Heat sink
- Speakers
- Front facing camera
- Rear facing camera
- Smart Card Cage
- Docking board connector
- Power Button Board
- System Board
- I/O Board
- WWAN Antenna
- Microphone
- Display cable
- Back cover
- System setup
- Entering BIOS without keyboard
- System setup options
- General screen options
- System Configuration screen options
- System Configuration screen options
- Video screen options
- Security screen options
- Secure Boot
- Intel software Guard Extensions
- Performance screen options
- Power Management screen options
- POST Behavior
- Virtualization Support options
- Wireless screen options
- Maintenance
- System logs screen options
- System Log
- Updating the BIOS
- Updating your system BIOS using a USB flash drive
- System and setup password
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Enhanced Pre-boot System Assessment - eDiags2.0
- System-diagnostic lights
- LED Indicators and Characteristics
- Kickstand open status behavior
- Updating the BIOS using the USB drive in Windows
- Updating the BIOS in Windows
- Backup media and recovery options
- Wi-Fi power cycle
- Flea power release
- Getting help
Dell Latitude 7210 2-in-1 Service Manual
Removing the display panel assembly
About this task
NOTE:There are two different configurations of the Latitude 7210 2-in-1:
- Non-security configuration with non-captive screws.
- Security configuration with captive screws.
Latitude 7210 2-in-1 has the kickstand power on feature. When the kickstand is deployed, the tablet will power on. If the tablet is powered on with the kickstand deployed, press and hold the power button to turn off the tablet, and then begin the tablet disassembly. There is no need to close the kickstand, proceed to remove the screws securing the display assembly.
Steps
- Follow the procedure in Before working inside your tablet.
- Remove the:
- Press the release tabs and lift the display back cover upwards.
- Remove the six screws (non-security configuration) and loosen the six captive screws (security configuration) securing the display assembly of Latitude 7210 2-in-1 to the system chassis.
- Using a plastic scribe, push the two release holes next to the hinges to loosen the display assembly from the display back cover.
- Close the display back cover.
- Flip the system over so the display assembly is facing upwards.
- Insert the plastic scribe into the gap created in step #1 and with a suction cup (optional), pry open the display assembly from the bottom-left corner of the front side of the system. Work your way around the right side of the display assembly.
- Carefully flip the display assembly over from the top edge and lay the display assembly face-down next to the display back cover. Do not pull away the display assembly from the base. The display assembly is still connected to the system board on the base via the display cable. Carefully flip the display assembly over and disconnect the display cable.
- Slide the battery power switch on the system board to
OFF.
- Remove the two M2x2.5 screws [1] securing the display cable bracket [2] to the system board and remove the display cable bracket.
- Disconnect the display cable [3] from the system board and remove the display panel assembly from the system.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\