Inspiron 14 5410 Service Manual

PDF

Installing the base cover

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the base cover and provides a visual representation of the installation procedure.

Installing the base cover

Installing the base cover

Steps

  1. Place and snap the base cover into place on the palm-rest and keyboard assembly.
  2. Tighten the two captive screws that secure the base cover to the palm-rest and keyboard assembly.
  3. Replace the five screws (M2x4) that secure the base cover to the palm-rest and keyboard assembly.

Next steps

  1. Exit Service Mode.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\