Inspiron 14 5410 Service Manual

PDF

Removing the base cover

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Enter Service Mode.

About this task

NOTE Before removing the base cover, ensure that there is no micro-SD card installed in the micro-SD card slot on your computer.

The following image(s) indicate the location of the base cover and provides a visual representation of the removal procedure.

Removing the base cover

Removing the base cover

Steps

  1. Remove the five screws (M2x4) that secure the base cover to the palm-rest and keyboard assembly.
  2. Loosen the two captive screws that secure the base cover to the palm-rest and keyboard assembly.
  3. Using a plastic scribe, pry the base cover from the bottom left and continue to work on the sides to open the base cover.
  4. Lift the base cover off the palm-rest and keyboard assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\