Inspiron 14 5410 Service Manual

PDF

Installing the display assembly

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the display assembly and provides a visual representation of the installation procedure.

Installing the display assembly

Steps

  1. Place the display assembly on a clean and flat surface with the display panel facing up.
  2. Gently place the palm-rest and keyboard assembly under the display hinges.
    CAUTION To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display assembly.
  3. Close the left-display hinge and align the screw holes on the left-display hinge with the screw holes on the I/O board.
  4. Replace the two screws (M2.5x4) that secure the left-display hinge to the palm-rest and keyboard assembly.
  5. Close the right-display hinge and align the screw holes on the right-display hinge with the screw holes on the system board.
  6. Replace the two screws (M2.5x4) that secure the right-display hinge to the palm-rest and keyboard assembly.
  7. Connect the display cable to the connector on the system board and close the latch.
  8. Adhere the tape that secures the display-cable connector latch to the system board.

Next steps

  1. Install the base cover.
  2. Exit Service Mode.
  3. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\