Inspiron 14 5410 Service Manual

PDF

Installing the I/O board

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the I/O board and provides a visual representation of the installation procedure.

Installing the I/O board

Steps

  1. Align the ports on the I/O board to the slots on the palm-rest and keyboard assembly.
  2. Place the I/O board on the palm-rest and keyboard assembly.
  3. Align the screw hole on the I/O board to the screw hole on the palm-rest and keyboard assembly.
  4. Replace the screw (M2x3) that secures the I/O board to the palm-rest and keyboard assembly.
  5. Close the left-display hinge and align the screw holes on the left-display hinge with the screw holes on the I/O board.
  6. Replace the two screws (M2.5x4) that secure the left-display hinge to the I/O board.
  7. Connect the I/O-board cable to the connector on the I/O board and close the latch.
  8. Connect the power-button with fingerprint-reader cable to the connector on the I/O board and close the latch.
    NOTE This step is only applicable for computers shipped with the optional fingerprint reader.
  9. Connect the coin-cell battery cable to the I/O board.

Next steps

  1. Install the base cover.
  2. Exit Service Mode.
  3. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\