Inspiron 14 5410 Service Manual

PDF

Installing the power-adapter port

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the power-adapter port and provides a visual representation of the installation procedure.

Installing the power-adapter port

Steps

  1. Connect the power-adapter port cable to the system board.
  2. Adhere the tape that covers the power-adapter port connector on the system board.
  3. Route the power-adapter port cable through the routing guides on the palm-rest and keyboard assembly.
  4. Place the power-adapter port into the slot on the palm-rest and keyboard assembly.
  5. Close the right-display hinge and align the screw holes on the right-display hinge with the screw holes on the system board.
  6. Replace the two screws (M2.5x4) that secures the right-display hinge to the system board.

Next steps

  1. Install the base cover.
  2. Exit Service Mode.
  3. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\