Inspiron 14 5410 Service Manual

PDF

Installing the touchpad

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the touchpad and provides a visual representation of the installation procedure.

Installing the touchpad

Steps

  1. Place the touchpad on the palm-rest and keyboard assembly.
  2. Turn the computer over and open the display to ensure that the touchpad is equally aligned on all sides.
    NOTE The image below shows the proper touchpad alignment for your computer.
    Image: Proper touchpad alignment
  3. Close the display and place the computer in the position shown.
  4. Replace the two screws (M2x1.8) that secure the touchpad to the palm-rest and keyboard assembly.
  5. Place the touchpad bracket on the touchpad.
  6. Align the screw holes on the touchpad bracket to the screw holes on the palm-rest and keyboard assembly.
  7. Replace the three screws (M1.6x2) that secure the touchpad bracket to the palm-rest and keyboard assembly.
  8. Adhere the tapes that secure the touchpad to the palm-rest and keyboard asssembly.
  9. Connect the touchpad cable to the touchpad and close the latch.

Next steps

  1. Install the 3-cell battery or the 4-cell battery, whichever applicable.
  2. Install the base cover.
  3. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\